828RC Redcat Ascent Apex Rear Cantilever Suspension Conversion Kit with INJORA Shocks

COMPLETE REAR SUSPENSION CONVERSION - INJORA OIL SHOCKS INCLUDED

Bring the compact bellcrank-operated cantilever suspension of the 828RC King Snake system to your Redcat Ascent Apex. This complete rear cantilever conversion includes the same shock assemblies, connecting rods, bearings, and hardware components as our King Snake kit, with Apex-specific adjustable mounting rails, revised bellcrank linkage fitment, and the correct Apex mounting bolts.

Features

• Redcat Ascent Apex-specific rear cantilever suspension geometry
• Two included INJORA 45 mm FCX24 oil shocks
• Adjustable mounting positions for suspension setup and ride-height tuning
• Adjustable connecting rods and redesigned Apex-specific bellcranks
• Compact shock layout with bellcrank-operated rear suspension
• Complete mounting hardware and bearings included

Complete Kit Includes

• 2 Apex-specific adjustable rear mounting rails / brackets
• 2 Apex-specific bellcranks
• 2 INJORA 45 mm FCX24 oil shocks
• 4 bellcrank bearings (2 per bellcrank)
• 4 rod ends with pivot balls
• 2 M2.5 × 15 mm grub screws for the adjustable connecting rods
• Assorted M2 and M2.5 hardware for the Apex installation, including the fasteners shown in the guide below
• Bellcrank pivot spacers / washers

Apex Installation — Bolt Sizes & Locations

1. Shock to mounting rail: M2 × 12
2. Mounting rail to chassis: M2 × 8
3. Shock to bellcrank: M2 × 8
4. Bellcrank pivot to rail mount: M2.5 × 12
5. Adjustable rod link to bellcrank: M2 × 8

IMPORTANT: Hardware is installed on both sides where applicable. Install the included spacer / washer behind the bellcrank, between the bellcrank and the mounting rail. PLEASE PRETHREAD BOLTS PRIOR TO INSTALLATION.

828RC APEX CANTILEVER HARDWARE SIZES & LOCATIONS — INSTALLATION GUIDE

Click image to open full-size installation guide.

Compatibility

Designed specifically for the Redcat Ascent Apex. This is the Apex-specific version; the 828RC / DBRC King Snake TRX-4M kit uses different mounting geometry and hardware. Confirm clearance and suspension travel during installation.

3D Printed Parts Disclaimer

Printed components are manufactured in-house by 828RC and may show minor layer lines or surface marks. Avoid excessive heat, prolonged direct sunlight, and over-tightening bolts in printed parts.

Made to Order

Typical processing time is 2–3 business days, but may take up to 2 weeks depending on workload and order volume.